Suzuki 2005 GSF1200 User Manual

Charging System: 1J-10
• Tighten the generator driven gear nut to the specified
torque.
Tightening torque
Generator driven gear nut (c): 55 N·m (5.5 kgf-m,
4.0 lb-ft)
NOTE
After tightening the generator driven gear nut
to the specified torque, stake the nut using a
punch.
Generator Parts Inspection
B649G11A06012
Refer to “Generator Disassembly and Assembly: ”.
Rotor Bearing
Inspect the rotor bearings for abnormal noise. Also,
rotate the rotor bearings by hand and make sure that
they rotate smoothly.
If there is unusual, replace the bearing with a new one.
Generator Driven Gear Damper
Inspect the generator driven gear dampers for wear and
damage. If any defects are found, replace the generator
driven gear dampers as a set.
NOTE
When installing the generator driven gear
dampers, apply SUZUKI MOLY PASTE to the
damper surface.
: Moly paste 99000–25140 (SUZUKI Moly paste
or equivalent)
Stater Coil Continuity Check
Measure the continuity between the lead wires of the
stator coil using a tester.
If there is no continuity, replace the stator.
Also, check that the stator is properly insulated.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity test ( )
(b)
7
(b)
7
(c)
I649G11A0028-01
Play
Pla
y
I649G11A0029-01
I649G11A0030-01
P 1
P 2
P 3
P 4
I649G11A0031-01
P 1
P 2
P 3
P 4
]
]
]
I649G11A0032-01

Suzuki 2005 GSF1200 Specifications

General

Displacement	1157 cc
Bore x Stroke	79.0 mm x 59.0 mm
Compression Ratio	9.5:1
Ignition	Electronic ignition (transistorized)
Lubrication	Wet sump
Transmission	6-speed constant mesh
Final Drive	Chain
Front Suspension	Telescopic, coil spring, oil damped
Rear Suspension	Link type, coil spring, oil damped
Front Brakes	Dual hydraulic disc
Rear Brakes	Single hydraulic disc
Seat Height	790 mm (31.1 in)
Ground Clearance	135 mm (5.3 in)
Engine Type	4-stroke, 4-cylinder, DOHC
Front Tire	120/70 ZR17
Rear Tire	180/55 ZR17
Fuel Tank Capacity	20.0 L (5.3 US gal)
Overall Length	2, 140 mm (84.3 in)
Overall Width	790 mm (31.1 inches)