Manual Transmission: 5B-21
Gearshift Linkage Inspection
B649G15206036
Refer to “Gearshift Shaft / Gearshift Cam Driven Gear
Removal and Installation: ”.
Gearshift Shaft (Gearshift Arm)
Check the gearshift shaft (Gearshift arm) for bends or
wear.
Check the return spring on the gearshift arm for damage
or fatigue.
If any defects are found, replace the defective part(-s).
Gearshift Shaft Oil Seal
Inspect the gearshift shaft oil seal’s lip for damage or
wear. If any defect is found, replace the oil seal with a
new one.
Gearshift Shaft Hole
Check the gearshift shaft hole for damage or wear.
Gearshift Shaft Oil Seal Removal and
Installation
B649G15206037
Removal
1) Remove the gearshift shaft. Refer to “Gearshift Shaft
/ Gearshift Cam Driven Gear Removal and
Installation: ”.
2) Remove the gearshift shaft oil seal from the lower
crankcase.
Installation
Install the oil seal in the reverse order of removal.
Pay attention to the following points:
CAUTION
!
The removed oil seal must be replaced with a
new one.
• Install the oil seal using the special tool.
Special tool
(A): 09913–70210 (Bearing installer set)
• Apply SUZUKI SUPER GREASE “A” onto the oil seal
lip.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
I649G1520074-01
I649G1520075-01
I649G1520076-01
I649G1520077-01
(A)
I649G1520078-02
To Next Page
Loading...
Need help?
General
