4B-6 Front Brakes:
Front Brake Disc Removal and Installation
B649G14206017
Removal
1) Remove the front wheel assembly. Refer to “Front
Wheel Assembly Removal and Installation: in
Section 2D”.
2) Remove the front brake disc.
Installation
Install the front brake disc in the reverse order of
removal. Pay attention to the following points:
• Make sure that the brake discs are clean and free of
any grease.
• Apply THREAD LOCK SUPER “1360” to the brake
disc bolts and tighten them to the specified torque.
: Thread lock cement 99000–32130 (Thread
Lock Cement Super 1360 or equivalent)
Tightening torque
Brake disc bolt (a): 23 N·m (2.3 kgf-m, 16.5 lb-ft)
Front Brake Disc Inspection
B649G14206018
Brake Disc Thickness
Check the brake disc for damage or cracks and measure
the thickness using the micrometer.
Replace the brake disc if the thickness is less than the
service limit or if defect is found.
Special tool
(A): 09900–20205 (Micrometer (0-25mm))
Brake disc thickness
Service limit (Front): 4.5 mm (0.18 in)
Brake Disc Runout
1) Remove the front brake caliper. Refer to “Front
Brake Caliper Removal and Installation: ”.
2) Measure the runout using the dial gauge.
Replace the disc if the runout exceeds the service
limit.
Special tool
(A): 09900–20607 (Dial gauge (1/100mm,
10mm))
: 09900–20701 (Magnetic stand)
Brake disc runout
Service limit: 0.30 mm (0.012 in)
3) Install the front brake caliper. Refer to “Front Brake
Caliper Removal and Installation: ”.
I649G1420017-01
(a)
(a)
I649G1420018-02
(A)
I649G1420019-02
(A)
I649G1420020-02
To Next Page
Loading...
Need help?
General
