9B-6 Lighting Systems:
Rear Combination Light Removal and
Installation
B649G19206016
Removal
1) Remove the seat tail cover. Refer to “Exterior Parts
Removal and Installation: in Section 9D”.
2) Remove the rear combination light (1) from the seat
tail cover.
Installation
Install the rear combination right in the reverse order of
removal. Pay attention to the following point:
• Tighten the rear combination light mounting bolts to
the specified torque.
Tightening torque
Rear combination light mounting bolt: 2.0 N·m (0.2
kgf-m, 1.5 lb-ft)
Brake Light Bulb / Taillight Bulb Replacement
B649G19206017
CAUTION
!
If you touch the bulb with your bare hands,
clean the bulb with a cloth moistened with
alcohol or soapy water to prevent premature
bulb failure.
1) Remove the seat. Refer to “Exterior Parts Removal
and Installation: in Section 9D”.
2) Remove the tool set (1).
3) Remove the bulb socket by turning it
counterclockwise.
4) Replace the bulb (2).
5) Reinstall the removed parts.
1
I649G1920019-01
1
I649G1920020-01
I649G1920021-01
2
I649G1920022-01
To Next Page
Loading...
Need help?
General
