Combination Meter / Fuel Meter / Horn: 9C-4
Combination Meter LED Check
B649G19306015
Check that the LEDs (Oil pressure indicator light and
Meter panel illumination) immediately light up when the
ignition switch is turned to ON.
Check that other LEDs (Neutral indicator light, High-
beam indicator light and Turn signal indicator lights) light
up/go off by operating each switch.
If abnormal condition is found, replace the combination
meter unit with a new one after checking its wire
harness/coupler.
Fuel Level Indicator Inspection
B649G19306016
Inspect the fuel level indicator in the following
procedures:
1) Disconnect the fuel level gauge wire coupler (1) and
remove the fuel tank. Refer to “Fuel Tank Removal
and Installation: in Section 1G”.
2) Connect a jumper wire “A” between the Y/B and B/W
lead wires from the wire harness.
3) Turn the ignition switch to ON.
4) Check if the fuel level indicator (LCD) indicates full
position.
NOTE
It takes approx. 30 seconds that the fuel level
indicator indicates the detected fuel level.
5) Turn the ignition switch to OFF and disconnect a
jumper wire “A”.
6) Connect a 180 Ω resister “B” between the Y/B and B/
W lead wires from the wire harness.
The fuel level indicator is operating correctly if the
LCD bars decrease to empty when the ignition
switch is turned to ON.
I649G1930008-01
1
I649G1930009-01
1. Fuel gauge wire coupler
1. Fuel gauge wire coupler
“A”
1
I649G1930010-01
1
“B”
I649G1930011-01
To Next Page
Loading...
Need help?
General
