Wheels and Tires: 2D-17
2) Remove the tire. Refer to “Tire Removal and
Installation: ”.
3) Remove the air valve (1) from the wheel.
Installation
Install the air valve in the reverse order of removal. Pay
attention to the following points:
• Any dust or rust around the valve hole (2) must be
cleaned off.
• Install the air valve (4) in the wheel (3).
CAUTION
!
• Be careful not to damage the lip (5) of
valve.
• Replace the air valve with a new one.
NOTE
To properly install the valve into the valve
hole, apply a special tire lubricant or neutral
soapy liquid to the valve.
Wheel Balance Check and Adjustment
B649G12406026
Check and adjust the wheel balance in the following
procedures:
1) Removal the wheel assembly. Refer to “Front Wheel
Assembly Removal and Installation: ” and “Rear
Wheel Assembly Removal and Installation: ”.
2) Remove the mounting drum from the rear wheel.
(For rear wheel)
Refer to “Rear Wheel Assembly Removal and
Installation: ”.
3) Check the wheel balance using the balancer and
adjust the wheel balance if necessary.
CAUTION
!
For operating procedures, refer to the
instructions supplied by the wheel balancer
manufacturer.
4) When installing the balancer weights (1) to the wheel
(2), set the two balancer weights on both sides of
wheel rim.
CAUTION
!
Weight difference between the two balancer
weights must be less than 10 g.
5) Recheck the wheel balance.
6) Install the mounting drum to the rear wheel. (For rear
wheel)
Refer to “Rear Wheel Assembly Removal and
Installation: ”.
7) Install the wheel assembly. Refer to “Front Wheel
Assembly Removal and Installation: ” and “Rear
Wheel Assembly Removal and Installation: ”.
3. Wheel 4. Valve 5. Valve lip
1
I649G1240046-01
2
I649G1240047-01
3
4
5
I649G1240048-01
1
2
I649G1240049-01
To Next Page
Loading...
Need help?
General
