Emission Control Devices: 1B-11
Crankcase Breather (PCV) Hose / Reed Valve /
Cover Removal and Installation
B837H11206007
Removal
1) Lift and support the fuel tank with the prop stay.
Refer to “Fuel Tank Removal and Installation in
Section 1G (Page 1G-9)”.
2) Remove the air cleaner box. Refer to “Air Cleaner
Box Removal and Installation in Section 1D
(Page 1D-7)”.
3) Remove the throttle body. Refer to “Throttle Body
Removal and Installation in Section 1D (Page 1D-
10)”.
4) Disconnect the crankcase breather (PCV) hose (1).
5) Remove the crankcase breather (PCV) reed valve
cover (2).
6) Remove the crankcase breather (PCV) reed valve
(3).
7) Remove the thermostat. Refer to “Thermostat
Removal and Installation in Section 1F (Page 1F-9)”.
8) Remove the EXCVA (4).
9) Remove the crankcase breather (PCV) cover (5) and
gasket.
Installation
Installation is in the reverse order of removal.
Pay attention to the following points:
• Install the new gasket (1).
CAUTION
!
Replace the gasket (1) with a new one.
• Connect the crankcase breather (PCV) hose securely.
Refer to “Throttle Body Construction in Section 1D
(Page 1D-9)”.
1
2
I837H1120018-02
3
I837H1120019-01
4
I837H1120021-01
5
I837H1120020-01
1
I837H1120022-02
To Next Page
Loading...
Need help?
General
