1F-7 Engine Cooling System:
3) Any leakage from the connecting section should be
corrected by proper tightening. Refer to “Water Hose
Routing Diagram (Page 1F-3)”.
4) After finishing the water hoses inspection, reinstall
the removed parts.
Water Hose Removal and Installation
B837H11606006
Removal
1) Remove the under cowlings. Refer to “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
11)”.
2) Drain engine coolant. Refer to “Cooling System
Inspection in Section 0B (Page 0B-12)”.
3) Remove the fuel tank. Refer to “Fuel Tank Removal
and Installation in Section 1G (Page 1G-9)”.
4) Remove the water hose as shown in the water hose
routing diagram. Refer to “Water Hose Routing
Diagram (Page 1F-3)”.
Installation
1) Install the water hose as shown in the water hose
routing diagram. Refer to “Water Hose Routing
Diagram (Page 1F-3)”.
2) Install the fuel tank. Refer to “Fuel Tank Removal
and Installation in Section 1G (Page 1G-9)”.
3) Pour engine coolant and bleed air from the cooling
circuit. Refer to “Cooling System Inspection in
Section 0B (Page 0B-12)”.
4) Install the under cowlings. Refer to “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
11)”.
Radiator Reservoir Tank Inspection
B837H11606008
Inspect the radiator reservoir tank in the following
procedures:
1) Remove the right under cowling. Refer to “Exterior
Parts Removal and Installation in Section 9D
(Page 9D-11)”.
2) Inspect the radiator reservoir tank cooling leaks. If
any defects are found, replace the radiator reservoir
tank with a new one.
3) Reinstall the removed parts.
I837H1160012-01
I837H1160013-01
I837H1160014-01
I837H1160015-01
I837H1160016-01
To Next Page
Loading...
Need help?
General
