Fuel System: 1G-7
Fuel Pump Relay Inspection
B837H11706004
Refer to “Electrical Components Location in Section 0A
(Page 0A-7)”.
Inspect the fuel pump relay in the following procedures:
1) Remove the front seat. Refer to “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
11)”.
2) Remove the fuel pump relay (1).
3) First, check for insulation with the tester between
terminals “A” and “B”. Next, check for continuity
between “A” and “B” with 12 V voltage applied,
positive (+) to terminal “C” and negative (–) to
terminal “D”. If continuity does not exist, replace the
relay with a new one.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity test ( )
Fuel Hose Inspection
B837H11706005
Refer to “Fuel Line Inspection in Section 0B (Page 0B-
10)”.
Fuel Level Gauge Inspection
B837H11706006
Refer to “Fuel Level Gauge Inspection in Section 9C
(Page 9C-5)”.
1
I837H1170007-01
“A”
“B”
“C”
“D”
I718H1170013-01
To Next Page
Loading...
Need help?
General
