2D-16 Wheels and Tires:
4) Install the valve core and inflate the tire.
WARNING
!
• Do not inflate the tire to more than 400 kPa
(4.0 kgf/cm
2
, 57 psi). If inflated beyond this
limit, the tire can burst and possibly cause
injury. Do not stand directly over the tire
while inflating.
• In the case of preset pressure air inflator,
pay special care for the set pressure
adjustment.
5) In this condition, check the “rim line” “B” cast on the
tire side walls. The line must be equidistant from the
wheel rim all around.
6) If the distance between the rim line and wheel rim
varies, this indicates that the bead is not properly
seated. If this is the case, deflate the tire completely
and unseat the bead for both sides. Coat the bead
with lubricant and fit the tire again.
7) When the bead has been fitted properly, adjust the
pressure to specification.
8) As necessary, adjust the tire balance. Refer to
“Wheel Balance Check and Adjustment (Page 2D-
18)”.
Cold inflation tire pressure
9) Install the mounting drum to the rear wheel.
(For rear wheel)
Refer to “Rear Wheel Assembly Removal and
Installation (Page 2D-11)”.
10) Install the wheel assembly. Refer to “Front Wheel
Assembly Removal and Installation (Page 2D-4)”
and “Rear Wheel Assembly Removal and Installation
(Page 2D-11)”.
Wheel / Tire / Air Valve Inspection and Cleaning
B837H12406012
Refer to “Tire Removal and Installation (Page 2D-15)”.
Wheel
Wipe the wheel clean and check for the following points:
• Distortion and crack
• Any flaws and scratches at the bead seating area.
• Wheel rim runout. Refer to “Front Wheel Related
Parts Inspection (Page 2D-6)” and “Rear Wheel
Related Parts Inspection (Page 2D-11)”.
Tire
Tire must be checked for the following points:
• Nick and rupture on side wall
• Tire tread depth (Refer to “Tire Inspection in Section
0B (Page 0B-19)”.)
• Tread separation
• Abnormal, uneven wear on tread
• Surface damage on bead
• Localized tread wear due to skidding (Flat spot)
• Abnormal condition of inner liner
Front Rear
Solo
riding
250 kPa
(2.50 kgf/cm
2
, 36 psi)
250 kPa
(2.50 kgf/cm
2
, 36 psi)
Dual
riding
250 kPa
(2.50 kgf/cm
2
, 36 psi)
290 kPa
(2.90 kgf/cm
2
, 42 psi)
“B”
I649G1240040-02
I649G1240041-02
I649G1240042-02
I649G1240043-02
To Next Page
Loading...
Need help?
General
