Front Brakes: 4B-7
Brake Pad Spring
Inspect the brake pad spring for damage and excessive
bend. If any damage is found, replace it with a new one.
Front Brake Disc Removal and Installation
B837H14206007
Removal
1) Remove the front wheel assembly. Refer to “Front
Wheel Assembly Removal and Installation in Section
2D (Page 2D-4)”.
2) Remove the front brake disc.
Installation
Install the front brake disc in the reverse order of
removal. Pay attention to the following points:
• Make sure that the brake disc is clean and free of any
grease.
• Apply thread lock to the brake disc bolts (1) and
tighten them to the specified torque.
: Thread lock cement 99000–32130 (Thread
Lock Cement Super 1360 or equivalent)
Tightening torque
Brake disc bolt (Front) (a): 18 N·m (1.8 kgf-m,
13.0 lb-ft)
Front Brake Disc Inspection
B837H14206008
Brake Disc Thickness
Check the brake disc for damage or cracks and measure
the thickness using the micrometer.
Replace the brake disc if the thickness is less than the
service limit or if defect is found.
Special tool
(A): 09900–20205 (Micrometer (0 – 25 mm))
Brake disc thickness
Service limit (Front): 4.5 mm (0.18 in)
I815H1420021-01
I837H1420018-01
(a)
1
(a)
1
I837H1420019-01
(A)
I649G1420019-03
To Next Page
Loading...
Need help?
General
