EasyManuals Logo
Home>Suzuki>Motorcycle>GSX-R600

Suzuki GSX-R600 User Manual

Suzuki GSX-R600
653 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #626 background imageLoading...
Page #626 background image
9C-3 Combination Meter / Fuel Meter / Horn:
Combination Meter Inspection
B837H19306004
LED Inspection
Check that the LEDs (FI, fuel, engine RPM, indicator
lights, immobilizer indicator light (E-02, 19, 24) and
meter panel illumination) immediately light up when the
ignition switch is turned ON.
Check that other LEDs (neutral, high-beam and turn
signal indicator lights) light up/go off by operating each
switch.
If abnormal condition is found, replace the combination
meter assembly with a new one after checking its wire
harness/coupler. Refer to “Combination Meter Removal
and Installation (Page 9C-2)”.
Stepping Motor Inspection and Adjustment
1) Check that the pointers calibrate immediately after
turning the ignition switch ON and stop at zero point.
If abnormal condition is found, replace the
combination meter assembly with a new one after
checking its wire harness/coupler.
NOTE
The pointers may not return to the proper
position even turning the ignition switch
on under low temperature condition. In
that case, you can reset the pointers to the
proper position by the following
instruction.
Complete the operation within 10 seconds
after the ignition switch has been turned
on.
2) With the ADJ button (1) pressed, turn the ignition
switch ON.
3) Keep pushing the ADJ button for more than 3 to 5
sec.
Pointers will return to the proper position right after
the completion of the operation. In the case of the
pointers not returning to the proper position after
doing above, replace the combination meter unit.
Refer to “Combination Meter Removal and
Installation (Page 9C-2)”.
Engine Coolant Temperature Indicator Light
Inspection
B837H19306005
Inspect the engine coolant temperature meter and
indicator light (LED) in the following procedures:
1) Lift and support the fuel tank. Refer to “Fuel Tank
Removal and Installation in Section 1G (Page 1G-
9)”.
2) Disconnect the ECT sensor coupler (1).
I837H1930004-01
I837H1930005-01
1
I837H1930006-01
Time Ignition switch Adjuster button (1)
PUSH
Release
Push
PushReset
OFF
ON
0
3 sec.
5 sec.
10 sec.
I837H1930023-01
1
I837H1930007-01

Table of Contents

Other manuals for Suzuki GSX-R600

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Suzuki GSX-R600 and is the answer not in the manual?

Suzuki GSX-R600 Specifications

General IconGeneral
BrandSuzuki
ModelGSX-R600
CategoryMotorcycle
LanguageEnglish

Related product manuals