Combination Meter / Fuel Meter / Horn: 9C-8
Ignition Switch Removal and Installation
B837H19306016
Refer to “Ignition Switch Removal and Installation in
Section 1H (Page 1H-11)”.
Horn Inspection
B837H19306017
NOTE
If the horn sound condition is normal, it is not
necessary to inspect the horn button
continuity.
Horn Button Inspection
1) Remove the air cleaner box. Refer to “Air Cleaner
Box Removal and Installation in Section 1D
(Page 1D-7)”.
2) Disconnect the left handlebar switch lead wire
coupler (1).
3) Inspect the horn button for continuity with a tester.
If any abnormality is found, replace the left
handlebar switch assembly with a new one.
Refer to “Handlebar Removal and Installation in
Section 6B (Page 6B-2)”.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
Horn Inspection
1) Disconnect the horn coupler (1).
2) Connect a 12 V battery to the horn terminals. If the
sound is not heard from the horn, replace the horn
with a new one.
3) Connect the horn coupler.
Horn Removal and Installation
B837H19306018
Removal
1) Disconnect the horn coupler (1).
2) Remove the horn (2) by removing the mounting
bolts.
Installation
Install the horn in the reverse order of removal.
1
I837H1930016-01
I718H1930028-03
1
I837H1930017-01
I837H1930018-01
1
2
I837H1930019-01
To Next Page
Loading...
Need help?
General
