4A-14 Brake Control System and Diagnosis:
• Tighten the pivot bolt (1) and lock-nut (2) to the
specified torque.
Tightening torque
Brake lever pivot bolt (a): 1 N·m (0.1 kgf-m, 0.7
lb-ft)
Brake lever pivot bolt lock-nut (b): 6 N·m (0.6
kgf-m, 4.5 lb-ft)
• When installing the brake light switch, align the
projection on the switch with the hole in the master
cylinder.
Front Brake Master Cylinder Parts Inspection
B837H14106014
Refer to “Front Brake Master Cylinder / Brake Lever
Disassembly and Assembly (Page 4A-12)”.
Master Cylinder
Inspect the master cylinder bore for any scratches or
other damage.
Piston / Rubber Parts
Inspect the piston surface for any scratches or other
damage.
Inspect the primary cup, secondary cup and dust boot
for wear or damage.
(a)
1
(b)
2
I837H1410038-01
I837H1410039-01
I837H1410040-01
I837H1410041-01
To Next Page
Loading...
Need help?
General
