EasyManuals Logo
Home>Suzuki>Motorcycle>GSX-R600

Suzuki GSX-R600 User Manual

Suzuki GSX-R600
653 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #351 background imageLoading...
Page #351 background image
Engine Cooling System: 1F-10
Tighten the thermostat cover bolts to the specified
torque.
Tightening torque
Thermostat cover bolt (a): 10 N·m (1.0 kgf-m, 7.0
lb-ft)
Connect the water hoses securely. Refer to “Water
Hose Routing Diagram (Page 1F-3)”.
Pour engine coolant and bleed air from the cooling
circuit. Refer to “Cooling System Inspection in Section
0B (Page 0B-12)”.
Thermostat Inspection
B837H11606014
Inspect the thermostat in the following procedures:
1) Remove the thermostat. Refer to “Thermostat
Removal and Installation (Page 1F-9)”.
2) Inspect the thermostat pellet for signs of cracking.
3) Test the thermostat at the bench for control action.
CAUTION
!
Do not contact the thermostat (1) and
column thermometer (2) with a pan.
As the thermostat operating response to
water temperature change is gradual, do
not raise water temperature too quickly.
The thermostat with its valve open even
slightly under normal temperature must be
replaced.
4) Immerse the thermostat (1) in the water contained in
a beaker and note that the immersed thermostat is in
suspension.
5) Heat the water by placing the beaker on a stove and
observe the rising temperature on a thermometer
(2).
6) Read the thermometer just when opening the
thermostat. If this reading, which is the temperature
level at which the thermostat valve begins to open, is
out of the standard value, replace the thermostat
with a new one.
Thermostat valve opening temperature
Standard: Approx. 82 °C (180 °F)
7) Keep on heating the water to raise its temperature.
8) Just when the water temperature reaches specified
value, the thermostat valve should have been lifted
by at least 8 mm (0.31 in). A thermostat failing to
satisfy either of the two requirements (start-to-open
temperature and valve lift) must be replaced.
Thermostat valve lift “a”
Standard: Over 8 mm (0.31 in) and at 95 °C (203
°F)
9) Install the thermostat. Refer to “Thermostat Removal
and Installation (Page 1F-9)”.
(a)
I837H1160024-01
I837H1160025-01
“A”: String “B”: Water
I705H1160030-03
I705H1160031-04

Table of Contents

Other manuals for Suzuki GSX-R600

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Suzuki GSX-R600 and is the answer not in the manual?

Suzuki GSX-R600 Specifications

General IconGeneral
BrandSuzuki
ModelGSX-R600
CategoryMotorcycle
LanguageEnglish

Related product manuals