1E-6 Engine Lubrication System:
7) Stop the engine and remove the oil pressure gauge
and attachment.
8) Reinstall the main oil gallery plug (1) and tighten it to
the specified torque.
CAUTION
!
Use a new gasket to oil leakage.
Tightening torque
Main oil gallery plug (M16) (a): 35 N·m (3.5 kgf-
m, 25.5 lb-ft)
9) Check the engine oil level. Refer to “Engine Oil and
Filter Replacement in Section 0B (Page 0B-10)”.
10) Install the right under cowling. Refer to “Exterior
Parts Removal and Installation in Section 9D
(Page 9D-11)”.
Repair Instructions
Engine Oil and Filter Replacement
B837H11506001
Refer to “Engine Oil and Filter Replacement in Section
0B (Page 0B-10)”.
Engine Oil Level Inspection
B837H11506002
Refer to “Engine Oil and Filter Replacement in Section
0B (Page 0B-10)”.
Oil Pan / Oil Strainer / Oil Pressure Regulator
Removal and Installation
B837H11506003
NOTE
The oil pan/oil strainer/oil pressure can not
be serviced with the engine installed in the
frame.
Removal
1) Remove the engine assembly from the frame. Refer
to “Engine Assembly Removal in Section 1D
(Page 1D-19)”.
2) Remove the plate (1).
3) Remove the oil pan (2) and gasket.
4) Remove the oil strainer (3) and oil pressure regulator
(4).
Installation
Installation is in the reverse order of removal. Pay
attention to the following points:
• Apply grease to the O-rings.
CAUTION
!
Use the new O-rings to prevent oil leakage.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
(a)
1
I837H1150005-02
1
2
I837H1150006-01
3
4
I837H1150007-01
To Next Page
Loading...
Need help?
General
