Engine Cooling System: 1F-6
4) Disconnect the radiator outlet hose (3) and water
bypass hose (4).
5) Disconnect the radiator inlet hose (5) and oil cooler
water inlet hose (6).
6) Disconnect the cooling fan motor coupler (7).
7) Remove the radiator assembly by removing the
bolts.
8) Remove the cooling fan motor (8) from the radiator.
Installation
Install the radiator in the reverse order of removal. Pay
attention to the following points:
• Connect the radiator hoses securely. Refer to “Water
Hose Routing Diagram (Page 1F-3)”.
• Pour engine coolant. Refer to “Cooling System
Inspection in Section 0B (Page 0B-12)”.
• Bleed air from the cooling circuit. Refer to “Cooling
System Inspection in Section 0B (Page 0B-12)”.
Water Hose Inspection
B837H11606005
Inspect the water hoses in the following procedures:
1) Remove the under cowlings. Refer to “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
11)”.
2) Check the water hoses for crack, damage or engine
coolant leakage. If any defect is found, replace the
water hose with a new one.
3
4
I837H1160007-01
5
6
I837H1160008-01
7
I837H1160009-01
I837H1160010-01
8
I837H1160011-02
To Next Page
Loading...
Need help?
General
