Engine Electrical Devices: 1C-2
Installation
Install the CKP sensor/crankshaft rotation signal sensor
in the reverse order of removal. Refer to “Generator
Removal and Installation” in Section 1J (Page 1J-5).
IAP Sensor Inspection
BA02J21306005
Refer to “DTC “17” (P0105-H/L): IAP Sensor Circuit
Malfunction” in Section 1A (Page 1A-40).
IAP Sensor Removal and Installation
BA02J21306006
Removal
1) Remove the throttle body. Refer to “Throttle Body
Removal and Installation” in Section 1D (Page 1D-
15).
2) Remove the IAP sensor (1) from the throttle body.
Installation
Install the IAP sensor in the reverse order of removal.
Pay attention to the following points:
• Apply thin coat of engine oil to the new O-ring (1).
CAUTION
!
Replace the O-ring with a new one.
TP Sensor Inspection
BA02J21306007
Refer to “DTC “14” (P0120-H/L): TP Sensor Circuit
Malfunction” in Section 1A (Page 1A-27).
TP Sensor Removal and Installation
BA02J21306008
Removal
1) Remove the exhaust pipe cover (1).
2) Remove the upper engine mounting bracket (2).
3) Disconnect the TP sensor coupler (3).
4) Remove the upper engine mounting bracket (LH)
(4).
1
IA02J1130003-01
1
IA02J1130004-03
1
IA02J1130022-01
2
IA02J1130023-01
3
IA02J1130021-02
4
IA02J1130006-02
To Next Page
Loading...
Need help?
General
