Engine Lubrication System: 1E-5
• Install the oil pump idle gear (5) and snap ring (6).
• Reinstall the clutch. Refer to “Clutch Installation” in
Section 5C (Page 5C-8).
Oil Pump No. 2 Components
BA02J21506008
Oil Pump No. 2 Removal and Installation
BA02J21506009
Removal
1) Drain the engine oil. Refer to “Engine Oil Inspection
and Replacement” in Section 0B (Page 0B-5).
2) Remove the generator cover. Refer to “Generator
Removal and Installation” in Section 1J (Page 1J-5).
3) Remove the oil pump No. 2 (1).
4) Remove the oil pump No. 2 shaft (2), pin (3), inner
rotor (4) and outer rotor (5).
5) Remove the snap ring (6) with the special tool.
Special tool
: 09900–06108 (Snap ring remover (Close
type))
6) Remove the oil pump No. 2 strainer (7).
1. Oil pump No. 2 5. Oil pump No. 2 shaft
2. Inner rotor : 11 N⋅m (1.1 kgf-m, 8.0 lbf-ft)
3. Outer rotor : Apply engine oil.
4. Oil pump No. 2 strainer : Do not reuse.
6
5
IA02J1150033-01
FWD
1
2
3
4
5
(a)
IA02J1150012-02
1
IA02J1150013-01
2
3
4
5
IA02J1150014-01
6
7
IA02J1150015-01
To Next Page
Loading...
Need help?
General
