Suzuki RMX450Z Service Manual

Rear Suspension: 2C-19
Cushion Rod
Inspect the cushion lever for damage. If any defect is
found, replace the cushion rod with a new one.
Cushion Rod Bearing Removal and Installation
BA02J22306017
Removal
1) Remove the following parts from the cushion rod.
• Collar (1)
• Dust seal (2)
•Washer (3)
• Spacer (4)
2) Remove the needle bearings.
3) Remove the cushion rod bearing with the special
tool.
Special tool
(A): 09921–20240 (Bearing remover set)
Installation
CAUTION
!
The removed bearings must be replaced with
new ones.
1) Press the bearings into the cushion rod with the
special tool and suitable size socket wrench.
NOTE
When installing the bearing, stamped mark
on the bearing must face outside.
Special tool
(A): 09924–84521 (Bearing installer set)
2) Install the needle bearings.
IA02J1230071-01
1
2 2
4
1
33
IA02J1230072-01
IA02J1230073-01
“a”: 32 pcs (one sides)
(A)
IA02J1230074-02
(A)
IA02J1230075-01
“a”
IA02J1230076-01

Suzuki RMX450Z Specifications

General

Brand	Suzuki
Model	RMX450Z
Category	Motorcycle
Language	English