1E-8 Engine Lubrication System:
Installation
Install the oil reed valve and assemble the crankcase.
Refer to “Engine Bottom Side Assembly” in Section 1D
(Page 1D-55).
Oil Reed Valve Inspection
BA02J21506014
Inspect the oil reed valve in the following procedures:
• Remove the oil reed valve. Refer to “Oil Reed Valve
Removal and Installation” (Page 1E-7).
• Inspect the oil reed valve for wear and damage. If any
defects are found, replace the oil reed valve with a
new one.
Oil Gallery Oil Seal Removal and Installation
BA02J21506015
Refer to “Crankshaft Oil Seal / Bearing Inspection” in
Section 1D (Page 1D-62).
Oil Gallery Oil Seal Inspection
BA02J21506016
Refer to “Crankshaft Oil Seal / Bearing Removal and
Installation” in Section 1D (Page 1D-63).
Specifications
Service Data
BA02J21507001
Oil Pump
Tightening Torque Specifications
BA02J21507002
NOTE
The specified tightening torque is described in the following.
“Oil Pump No. 1 Components” (Page 1E-3)
“Oil Pump No. 2 Components” (Page 1E-5)
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List” in Section 0C
(Page 0C-8).
IA02J1150026-01
Item Standard Limit
Oil pressure (at 50 °C, 122 °F) 50 kPa (0.5 kgf/cm
2
, 7.1 psi) and more at 4 000 r/min —
Fastening part
Tightening torque
Note
N⋅mkgf-mlbf-ft
Oil gallery plug 10 1.0 7.0 )(Page 1E-3)
Oil pump No. 1 bolt 5.5 0.55 4.0 )(Page 1E-4)
Oil pump No. 2 bolt 11 1.1 8.0 )(Page 1E-6)
To Next Page
Loading...
Need help?
General
