1D-9 Engine Mechanical:
3) Remove the air cleaner box mounting bolts (2).
4) Remove the air cleaner box assembly (3) from the
seat rail.
Installation
Installation is in the reverse order of removal. Refer to
“Rear Shock Absorber Removal and Installation” in
Section 2C (Page 2C-5).
Throttle Cable Removal and Installation
BA02J21406005
Removal
1) Remove the fuel tank. Refer to “Fuel Tank Removal
and Installation” in Section 1G (Page 1G-5).
2) Remove the throttle cable as shown in the cable
routing diagram. Refer to “Throttle Cable Routing
Diagram” (Page 1D-2).
Installation
Install the throttle cable in the reverse order of removal.
Pay attention to the following points:
• Install the throttle cable as shown in the cable routing
diagram. Refer to “Throttle Cable Routing Diagram”
(Page 1D-2).
• Check the throttle cable play and proper operation.
Refer to “Throttle Cable Play Inspection and
Adjustment” in Section 0B (Page 0B-12).
Throttle Cable Inspection
BA02J21406006
Check that the throttle grip move smoothly from full open
to full close. If it does not move smoothly, lubricate the
throttle cable. Refer to “Throttle Cable Play Inspection
and Adjustment” in Section 0B (Page 0B-12).
Hot Starter Cable Removal and Installation
BA02J21406007
Removal
1) Remove the fuel tank. Refer to “Fuel Tank Removal
and Installation” in Section 1G (Page 1G-5).
2) Disconnect the hot starter cable end (1) from the
throttle body.
3) Remove the clamp (2).
2
IA02J1140264-01
2
IA02J1140265-01
3
IA02J1140136-03
2
1
IA02J1140244-01
To Next Page
Loading...
Need help?
General
