5B-8 Manual Transmission:
Transmission Oil Seal / Bearing Inspection
BA02J25206006
Refer to “Transmission Removal and Installation”
(Page 5B-3).
Oil Seal
Inspect the oil seal lips for wear or damage. If any
defects are found, replace the oil seal with new ones.
Refer to “Transmission Oil Seal / Bearing Removal and
Installation” (Page 5B-8).
Bearing
Rotate the bearing inner race by finger to inspect for
abnormal play, noise and smooth rotation while the
bearings are in the crankcase.
Replace the bearing if there is anything unusual. Refer
to “Transmission Oil Seal / Bearing Removal and
Installation” (Page 5B-8).
Transmission Oil Seal / Bearing Removal and
Installation
BA02J25206007
Oil Seal
Removal
1) Remove the engine sprocket. Refer to “Engine
Sprocket Removal and Installation” in Section 3A
(Page 3A-3).
2) Remove the engine sprocket spacer (1) and O-rings
(2).
3) Remove the driveshaft oil seal (3).
Installation
CAUTION
!
The removed oil seal and O-rings must be
replaced with new ones.
1) Install the drive shaft oil seal (1) with a suitable
socket wrench.
IA02J1520013-01
Play
Play
I933H1520033-01
2
1
IA02J1520061-01
3
IA02J1520066-01
1
IA02J1520062-02
To Next Page
Loading...
Need help?
General
