1E-2 Engine Lubrication System:
Diagnostic Information and Procedures
Engine Lubrication Symptom Diagnosis
BA02J21504001
Oil Pressure Check
BA02J21504002
Check the engine oil pressure periodically. This will give
a good indication of the condition of the moving parts.
NOTE
Before checking the oil pressure, check the
following.
• Oil level (Refer to “Engine Oil Filter
Replacement” in Section 0B (Page 0B-7).)
• Oil leaks (If leak is found, repair it.)
• Oil quality (If oil is discolored or
deteriorated, replace it.)
1) Remove the oil gallery plug (1).
2) Install the oil pressure gauge and attachment into
the main oil gallery.
3) Connect the multi circuit tester or tachometer to the
high-tension cord.
Special tool
(A): 09915–74511 (Oil pressure gauge set)
(B): 09940–40211 (Fuel pressure gauge
adapter)
(C): 09900–26006 (Engine tachometer)
4) Warm up the engine as follows:
Summer: 10 min. at 2 000 r/min
Winter: 20 min. at 2 000 r/min
5) After warm up, increase the engine speed to 4 000 r/
min (Observe the tachometer), and read the oil
pressure gauge.
If the oil pressure is lower or higher than the
specification, the following causes may be
considered.
Oil pressure specification
50 kPa (0.5 kgf/cm
2
, 7.1 psi) at 4 000 r/min, Oil
temp. at 50 °C (122 °F)
Condition Possible cause Correction / Reference Item
Engine overheats Insufficient amount of engine oil. Check level and add.
Defective oil pump. Replace.
Clogged oil circuit. Clean.
Incorrect engine oil. Change.
Exhaust smoke is dirty or
thick
Excessive amount of engine oil. Check level and drain.
Engine lacks power Excessive amount of engine oil. Check level and drain.
1
IA02J1150001-01
High oil pressure Low oil pressure
• Engine oil viscosity is too
high.
• Clogged oil passage.
• Combination of the
above items.
• Clogged oil filter.
• Oil leakage from the oil
passage.
• Damaged O-ring.
• Defective oil pump.
• Combination of the
above items.
(B)
(A)
(C)
IA02J1150002-03
To Next Page
Loading...
Need help?
General
