Starting System: 1I-2
Starter Motor will not Run
BA02J21904002
NOTE
Make sure the fuses are not blown and the battery is fully-charged before diagnosing.
Troubleshooting
Starter Motor Runs but Does not Crank the Engine
BA02J21904003
The starter motor runs when the transmission is in neutral, but does not run when the transmission is in any position
other than neutral.
Step Action Yes No
1 1) Shift the transmission into neutral.
2) Grasp the clutch lever, turn on the ignition switch and
listen for a click from the starter relay when the starter
button is pushed.
Is a click sound heard?
Go to step 2. Go to step 3.
2 Check if the starter motor runs when its terminal is
connected to the battery (+) terminal. (Do not use thin “wire”
because a large amount of current flows.)
Does the starter motor run?
• Faulty starter relay.
• Loose or
disconnected starter
motor lead wire.
• Loose or
disconnected
between starter relay
and battery (+)
terminal.
Faulty starter motor.
3 Measure the starter relay voltage at the starter relay
connectors (between Y/R (+) and B/W (–)) when the starter
button is pushed.
Is the voltage OK?
Go to Step 4. • Faulty ignition switch.
• Faulty engine stop
switch.
• Faulty clutch lever
position switch.
• Faulty starter button.
• Poor contact of
connector.
• Open circuit in wire
harness.
4 Check the starter relay. Refer to “Starter Relay Inspection”
(Page 1I-7).
Is the starter relay OK?
Poor contact of the
starter relay.
Faulty starter relay.
Step Action Yes No
1 Check the starter clutch. Refer to “Starter Torque Limiter /
Starter Idle Gear / Starter Clutch Removal and Installation”
(Page 1I-10).
Is the starter clutch OK?
• Open circuit in wire
harness.
• Poor contact of
connector.
Faulty starter clutch.
To Next Page
Loading...
Need help?
General
