Engine Electrical Devices: 1C-4
5) Turn on the ignition switch.
6) Measure the TP sensor output voltage between the
Y wire terminal (+) and B wire terminal (–).
Special tool
(A): 09900–25008 (Multi circuit tester set)
(B): 09900–25009 (Needle-point probe set)
Tester knob indication
Voltage ( )
TP sensor output voltage
0.53 – 0.68 V ((+) terminal: Y – (–) terminal: B)
7) If the TP sensor adjustment is necessary, remove
the upper engine mounting bracket (LH) (3).
8) Loosen the TP sensor mounting screw with the
special tool.
Special tool
: 09930–11950 (Torx wrench (T25))
9) Turn the TP sensor (4) and adjust the TP sensor until
the output voltage comes within specified valve.
10) Tighten the TP sensor mounting screw to the
specified torque.
Tightening torque
TP sensor mounting screw: 3.5 N·m (0.35 kgf-
m, 2.5 lbf-ft)
Special tool
: 09930–11950 (Torx wrench (T25))
11) Turn off the ignition switch.
12) Tighten the engine mounting bracket bolts (LH & RH)
(5) and engine mounting bolt (LH & RH) (6) to the
specified torque.
Tightening torque
Engine mounting bracket bolt (a): 40 N·m (4.0
kgf-m, 29.0 lbf-ft)
Engine mounting bolt (b): 55 N·m (5.5 kgf-m,
40.0 lbf-ft)
13) Install the exhaust pipe cover. Refer to “Exhaust
System Components” in Section 1K (Page 1K-1).
IAT Sensor Inspection
BA02J21306010
Refer to “DTC “21” (P0110-H/L): IAT Sensor Circuit
Malfunction” in Section 1A (Page 1A-48).
NOTE
IAT sensor resistance measurement method
is the same way as that of the ECT sensor.
Refer to “ECT Sensor Inspection” (Page 1C-
6).
IAT Sensor Removal and Installation
BA02J21306011
Removal
1) Remove the seat. Refer to “Exterior Parts Removal
and Installation” in Section 9D (Page 9D-1).
2) Remove the air cleaner element. Refer to “Air
Cleaner Element Removal and Installation” in
Section 1D (Page 1D-8).
(B)
(A)
IA02J1130026-01
3
IA02J1130011-02
4
IA02J1130012-02
(a)
5
(a)
5
(b)
6
(b)
6
IA02J1130027-03
To Next Page
Loading...
Need help?
General
