Wheels and Tires: 2D-6
Wheel
1) Remove the brake pads. Refer to “Front Brake Pad
Replacement” in Section 4B (Page 4B-2).
2) Make sure that the wheel runout checked as shown
in the figure does not exceed the service limit. An
excessive runout is usually due to worn or loosened
wheel bearings and can be reduced by replacing the
bearings. If bearing replacement fails to reduce the
runout, replace the wheel.
Wheel rim runout
Service limit (Axial and Radial): 2.0 mm (0.08 in)
3) Install the brake pads. Refer to “Front Brake Pad
Replacement” in Section 4B (Page 4B-2).
Wheel Bearing
Inspect the play of the wheel bearings by finger while
they are in the wheel. Rotate the inner race by finger to
inspect for abnormal noise and smooth rotation. Replace
the bearing if there is anything unusual. Refer to “Front
Wheel Dust Seal / Bearing Removal and Installation”
(Page 2D-6).
Front Wheel Dust Seal / Bearing Removal and
Installation
BA02J22406005
Removal
1) Remove the front wheel assembly. Refer to “Front
Wheel Assembly Removal and Installation”
(Page 2D-3).
2) Remove the dust seals (1) using the special tool.
Special tool
(A): 09913–50121 (Oil seal remover)
3) Remove the snap ring (2) and speed rotor (3).
Special tool
: 09900–06108 (Snap ring remover (Close
type))
4) Remove the bearings (4) using the special tool.
Special tool
(B): 09921–20240 (Bearing remover set)
IA02J1240008-01
I649G1240015-02
(A)
1
IA02J1240034-01
2
3
IA02J1240027-01
(B)
4
IA02J1240035-02
To Next Page
Loading...
Need help?
General
