6-COOLING SYSTEM COMPONENT 33
CHK
ADJ
NO. PART NO.
1 1221200-050000 KD150－U auxiliary water tank 1
PROCEDURE:
●Add coolant
When the engine is completely cooled, the vehicle can be straightened to accurately check the liquid level. If it
is lower than the "L" line, the coolant should be replenished in time. If the auxiliary tank has no or only a small
amount of coolant, check the cooling system first, and remove the leak before adding it.
Park the vehicle with the side brackets; turn the direction to the right and turn to the bottom.
Open the lid of the auxiliary water tank⑴ and add a small amount of coolant each time with a funnel. It is
appropriate to reach the position between "H" line and "L"line when the liquid level of the coolant is used to
support the vehicle.
CAUTION:
●Check regularly the cooling liquid surface. It should never be lower than "L" line.
●Change cooling liquid every two years is suggested.
●
Swallowing or inhaling cooling liquid would harm human body. Clean thoroughly the hands, face or explosing
skin every time after adding cooling liquid. If cooling liquid is swalled by accident, please contact toxication
center or hosipital. If it's inhaled, please move to open air. If it's spilt to the eye, clean it with big quantity of
clean water and see doctor in time. Be sure the cooling liquid is far away from children or pets.
●Engine cooling liquid must be suitable for aluminum radiator. The basic should be glycol. Cooling liquid
should be mixture of distilled water and concentrated cooling liquid under certain proportion. Be sure to choose
cooling liquid which is suitable for your local extreamly low temperature. The freezing point should be lower
than the local lowest temperature. Distilled water is the only kind of water acceptable. Other kind of water might
cause corrosion to engine cooling system or other more severe problems.
●Total volume of cooling liquid is 830ml.
●Cooling liquid might damage the coating of motorcycle. Be careful while adding. If it is spilt in small quantity,
please clean it immediately with soft cloth.
Fig.2 COOLING SYSTEM
COMPONENT
Add coolant
To Next Page
Loading...
Need help?
General
