13-MUFFLER COMPONENT 74
CHK
ADJ
NO. PART NO.
1 1251100-102000
（
）
2 1274100-057095
Flanging bushing φ6.2×φ8.5×3.5
＋
3 1244100-052000
Buffer rubber of flanging bushing
（
）
4 1070100-202000
KD150-U engine exhaust seal pad 1
5 1251300-058093
Hexagonal nut (color zinc) 2
6 1250105-021091
（
）
7 1250303-011093 GB6177.1 M8(environmental color) 1
PROCEDURE:
●Remove the muffler componet
Use a 4# inner hexagon to remove the 4 bolts ⑴ surrounding the component, remove the flange bushing ⑵
and the
cushion rubber ⑶, take out the surrounding component.
Using 12# sleeve fix the head of the bolt⑹,using 13# ring spanner remove the nut⑺,then take off the bolt⑹.
Hold the buffer component then use 6# inner hexagon socket or 12# sleeve remover the nut⑸.
Hold the bottom of the fender return pressure package with one hand, and grab the flange at the exhauster to
remove it. Wrap the flange with a rubber band or rope to prevent the flange from moving back and forth on the
front elbow and causing scratches.
Take off the exhaust seal pad⑷ from the exhaust.
CAUTION:
●The parts should be protected during disassembly to prevent damage to the paint.
●The muffler should be completely cooled before it is disassembled.
●Prevent foreign matter from entering the interior of the muffler.
●The muffler nozzle needs to be protected. If there is any deformation, it may cause air leakage.
●It is recommended that new seals be replaced each time the muffler front assembly is removed to prevent
airleakage.
Fig.1 MUFFLER
COMPONENT
Muffler component 1
To Next Page
Loading...
Need help?
General
