Quick start-up guide 29
Quick start-up guide
Contents of this chapter
This chapter contains the basic start-up sequence of the drive and additional
alternative checklists for starting up the drive with the ESP control program.
In this chapter, the drive is set up using ACS-AP-I control panel. You can also do the
start-up sequence using the Drive composer PC tool.
Before you start
Make sure that the drive has been mechanically and electrically installed as
described in the appropriate Quick installation guide and/or Hardware manual.
Safety
WARNING! All electrical installation and maintenance work on the drive should
be carried out by qualified electricians only.
Never work on the drive, the brake chopper circuit, the motor cable or the motor when
power is applied to the drive. Always make sure by measuring that no voltage is
actually present.
To Next Page
Loading...
Need help?
General
