Rockwell Automation Publication 2097-UM002D-EN-P - April 2017 105
Kinetix 350 Drive Safe Torque-off Feature Chapter 6
Wiring Your Safe Torque-off
Circuit
This section provides guidelines for wiring your Kinetix 350 safe torque-off
drive connections.
European Union Directives
If this product is installed within the European Union or EEC regions and has
the CE mark, the following regulations apply.
For more information on the concept of electrical noise reduction, refer to
System Design for Control of Electrical Noise Reference Manual, publication
GMC-RM001
.
EMC Directive
This unit is tested to meet Council Directive 2004/108/EC Electromagnetic
Compatibility (EMC) by using these standards, in whole or in part:
• EN 61800-3 - Adjustable Speed Electrical Power Drive Systems,
Part 3 - EMC Product Standard including specific test methods
• EN 61000-6-4 EMC - Emission Standard, Part 2 - Industrial
Environment
• EN 61000-6-2 EMC - Immunity Standard, Part 2 - Industrial
Environment
The product that is described in this manual is intended for use in an industrial
environment.
CE Conformity
Conformity with the Low Voltage Directive and Electromagnetic
Compatibility (EMC) Directive is demonstrated by using harmonized
European Norm (EN) standards that are published in the Official Journal of
the European Communities. The safe torque-off circuit complies with the EN
standards when installed according to instructions found in this manual.
CE Declarations of Conformity are available online at:
http://www.rockwellautomation.com/products/certification/ce
.
Low Voltage Directive
These units are tested to meet Council Directive 2006/95/EC Low Voltage
Directive. The EN 60204-1 Safety of Machinery-Electrical Equipment of
Machines, Part 1-Specification for General Requirements standard applies in
whole or in part. Additionally, the standard EN 50178 Electronic Equipment
for use in Power Installations apply in whole or in part.
To Next Page
Loading...
Need help?
General
