1F – 6IENGINE CONTROLS
DAEWOO V–121 BL4
EVAP Data Display
At idle / Upper Radiator / Closed Throttle / Park or Neutral / Closed loop / Acc. OFF
Scan Tool Parameter Units Displayed Typical Data
Engine Speed RPM µ100 rpm from the Desired rpm
Ignition Voltage Volts 12.0–15.0
Engine Coolant Temperature C – F 85³–115³C (185³–239³F) (Varies
with the coolant temperature)
Start Up Coolant Temperature C – F 4³–34³C (39³–93³F) Varies with
underhood temperature when start-
ing
Intake Air Temperature C – F 10³–80³C Varies with underhood
temperature
Start Up Intake Air Temperature C – F 12³ – 42³C (54³ – 108³F) Varies
with underhood temperature when
starting
Engine Run Time Seconds Varies (Since start up)
Fuel Level Sensor Volt 0.4–4.5
Fuel Gauge On/Off On
EVAP Purge Solenoid % 0–100
EVAP Vent Solenoid On/Off Off
EVAP Tank Vacuum Inches of H2O Depends on Pressure / Vacuum
Throttle Position Angle % 0% (up to 100% at wide open
throttle)
Throttle Position Sensor Volts 0.200–0.900 v (up to 5.0 at wide
open throttle)
IAC Position Counts 5–60
BPW Bank 1 mS 0–999.9
Air Fuel Ratio Ratio 14.6:1 (Varies)
Spark Degrees Varies
MAP kPa 25–35 kPa
BARO kPa 65–100 kPa (varies with altitude and
with the BARO pressure)
Calculated Load % 0–100
Vehicle Speed mph 0
Oxygen Sensor Bank 1 Sensor 1 mV 0––1000 and varying
Oxygen Sensor Bank 1 Sensor 2 mV 0–1000 and varying