Daewoo NUBIRA User Manual

4D – 10IFRONT DISC BRAKES
DAEWOO V–121 BL4
4. Remove the inner seal from the bore.
5. Remove the bleeder valve protector and the bleed-
er valve.
Assembly Procedure
1. Clean all parts in denatured alcohol or brake fluid.
Dry the parts with unlubricated compressed air and
blow out all passages in the housing and bleeder
valve.
2. Inspect the piston and caliper for scoring, nicks, or
corrosion. Replace any components which show
these conditions.
3. Install the caliper bleeder valve.
Important : Do not use a hone or any other procedure to
remove material from the caliper bore or piston.
4. Lubricate a new piston inner seal with brake fluid.
5. Install the piston inner seal into the groove in the
caliper bore.
6. Install the piston dust seal in its groove.
7. Lubricate the piston with brake fluid.
8. Push the piston inward until it is properly seated.
Make sure that the dust seal is in the correct
groove in the piston and caliper.
9. Reinstall the caliper. Refer to”Caliper”in this section.
10. Bleed the brake system. Refer toSection 4A, Hy-
draulic brakesor Section 4F, Antilock Brakes, if ap-
plicable.

Daewoo NUBIRA Specifications

General

Brand	Daewoo
Model	NUBIRA
Category	Automobile
Language	English