FRONT DISC BRAKES 4D – 7
DAEWOO V–121 BL4
Installation Procedure
Important : To guarantee uniform braking, always refinish
both rotors even if only one rotor is defective. If a rotor is
being replaced, use a new rotor on both sides of the ve-
hicle.
1. Install the rotor on the front wheel hub and install
the detent screw.
Tighten
Tighten the rotor detent screw to 4 NSm (35 lb–in).
2. Apply a few drops of thread–locking compound to
the bolts and install the caliper bracket.
Tighten
Tighten the caliper bracket–to–steering knuckle
mounting bolts to 95 NSm (70 lb–ft).
3. Install the brake pads and the caliper. See”Caliper”
in this section.
SPLASH SHIELD
Removal Procedure
1. Remove the rotor. Refer to ”Rotor” in this section.
2. Remove the screws for the splash shield from the
steering knuckle.
3. Remove the splash shield.
To Next Page
Loading...
Need help?
General
