INSTRUMENT/DRIVER INFORMATION 9E – 39
DAEWOO V–121 BL4
14. Remove the bolts that secure the bottom of the in-
strument panel to the floor.
15. Remove the bolts that secure the sides of the in-
strument panel to the body.
16. Disconnect the instrument panel electrical connec-
tors.
17. Remove the Instrument panel.
Installation Procedure
1. Position the instrument panel in the vehicle.
2. Connect the instrument panel electrical connectors.
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
3. Install the nuts securing the back of the instrument
panel to the bulkhead.
Tighten
Tighten the instrument panel–to–bulkhead nuts to 10
NSm (89 lb–in).
To Next Page
Loading...
Need help?
General
