POWER BOOSTER 4C – 3
DAEWOO V–121 BL4
POWER BOOSTER ASSEMBLY
Removal Procedure
1. Remove the master cylinder. Refer toSection 4B,
Master Cylinder.
2. Remove the brake lines to the hydraulic modulator
for vehicles equipped with ABS.
3. Remove the shaft and the rubber O–ring.
4. Remove the clip on the vacuum hose connection on
the booster.
5. Disconnect the brake stoplamp switch from the
brake pedal bracket.
6. Remove the brake pedal spring.
7. Disconnect the clip and the pushrod pin from the
pedal bracket assembly. Refer toSection 4A, Hy-
draulic Brakes.
To Next Page
Loading...
Need help?
General
