DOORS 9P – 33
DAEWOO V–121 BL4
Installation Procedure
1. Install the door seal trim.
2. Install the inside door handle. Refer to”Inside Door
Handle” in this section.
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
3. Install the door pull bracket with the screws.
Tighten
Tighten the door pull bracket screws to 3.5 NSm (31
lb–in).
4. Install the door trim panel. Refer to Section 9G, In-
terior Trim.
FRONT DOOR OPENING
WEATHERSTRIP
Removal Procedure
1. Remove the kick panel, the front rocker panel, and
the lower B–pillar trim panel. Refer to Section 9G,
Interior Trim.
2. Remove the door opening weatherstrip.