Daewoo NUBIRA User Manual

CLUTCH 5C0 – 9
DAEWOO V–121 BL4
CLUTCH PEDAL POSITION SWITCH
Removal Procedure
1. Remove the clutch pedal position switch by rotating
the switch and pulling it from the rear of the clutch
pedal bracket.
2. Disconnect the electrical connector.
Installation Procedure
1. Connect the electrical connector.
2. Install the clutch pedal position switch by inserting it
from the rear of the clutch pedal bracket and rotat-
ing the switch until it locks into position.
Adjustment Procedure
After the clutch pedal position switch is installed, adjust it
in the following manner:
1. Confirm that the engine starts when the clutch ped-
al is fully pressed down.
2. If the engine does not start when the clutch pedal is
fully pressed down, turn the clutch pedal position
switch adjusting screw until the clutch pedal posi-
tion switch is engaged so that the engine will start.
Do not adjust the screw so far down that it dam-
ages the clutch pedal position switch.
3. Confirm that the engine does not start when the
clutch pedal is released.
4. If the engine starts when the clutch pedal is re-
leased completely, replace the clutch pedal position
switch.

Daewoo NUBIRA Specifications

General

Brand	Daewoo
Model	NUBIRA
Category	Automobile
Language	English