4B – 6IMASTER CYLINDER
DAEWOO V–121 BL4
Installation Procedure
1. Lubricate the new seals with clean brake fluid.
Install the seals into the cylinder body.
2. Install the reservoir on the master cylinder body.
3. For vehicles with the manual transaxle, connect the
clip to the clutch hose connection to the master cyl-
inder.
4. Add brake fluid.
5. Raise and suitably support the vehicle.
6. Bleed the braking system. Refer toSection 4A, Hy-
draulic Brakes orSection 4F, Antilock Brake Sys-
tem.
7. Bleed the clutch master cylinder. Refer toSection
5C, Clutch.
8. Lower the vehicle.
9. Connect the reservoir electrical connector.
To Next Page
Loading...
Need help?
General
