Daewoo NUBIRA User Manual

HEATING AND VENTILATION SYSTEM 7A – 23
DAEWOO V–121 BL4
8. Install the instrument panel carrier assembly. Refer
to Section 9E, Instrumentation/Driver Information.
9. Fill the cooling system. Refer to Section 1D, Engine
Cooling.
10. Connect the negative battery cable.
Notice : If the vehicle is equipped with air conditioning, re-
fer to Section7B, Heater/Air Distributor Case Assembly.
11. Operate the controls to verify the proper function of
the heating and ventilating systems.
BLOWER MOTOR
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the glove box. Refer to 9E, Instrumenta-
tion/Driver Information.
3. Remove the footwell upper cover. Refer to Section
9E, Instrumentation/Driver Information.
4. Disconnect the blower motor electrical connector.
5. Remove the blower motor cooling hose.
6. Remove the screws that secure the motor to the
heater/air distributor case.
7. Remove the motor, the seal, and the shock mount
pads from the heater/air distributor case by gently
pulling the motor straight down and out.
Installation Procedure
1. Install the blower motor and the seal with the shock
mount pads in the heater/air distributor case. Hold
the blower motor in position.
2. Install the screws to secure the blower motor to the
heater/air distributor case.
Tighten
Tighten the blower motor retaining screws to 6 NSm
(53 lb–in).
3. Install the blower motor cooling hose.
4. Connect the blower motor electrical connector.
5. Connect the negative battery cable.
6. Confirm that the blower motor operates properly.
7. Replace the footwell upper cover. Refer to Section
9E, Instrumentation/Driver Information.
8. Replace the glove box. Refer to Section 9E, Instru-
mentation/Driver Information.

Daewoo NUBIRA Specifications

General

Brand	Daewoo
Model	NUBIRA
Category	Automobile
Language	English