9P – 10IDOORS
DAEWOO V–121 BL4
4. Remove the glass run.
Installation Procedure
1. Install the glass run.
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
2. Install the exterior garnish molding with the screws.
Tighten
Tighten the rear door exterior garnish molding screws
to 1.5 NSm (13 lb–in).
3. Install the interior garnish molding.
4. Install the rear door glass. Refer to Section 9L,
Glass and Mirrors.
To Next Page
Loading...
Need help?
General
