SECTION : 4E
REAR DISC BRAKES
CAUTION : Disconnect the negative battery cable before removing or installing any electrical unit or when a tool
or equipment could easily come in contact with exposed electrical terminals. Disconnecting thes cable will help
prevent personal injury and damage to the vehicle. The ignition must also be in LOCK unless otherwise noted.
TABLE OF CONTENTS
SPECIFICATIONS 4E–1. . . . . . . . . . . . . . . . . . . . . . . . . .
FASTENER TIGHTENING SPECIFICATIONS 4E–1.
DIAGNOSIS 4E–2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
LINING INSPECTION 4E–2. . . . . . . . . . . . . . . . . . . . . .
ROTOR INSPECTION 4E–2. . . . . . . . . . . . . . . . . . . . .
MAINTENANCE AND REPAIR 4E–3. . . . . . . . . . . . . . .
ON–VEHICLE SERVICE 4E–3. . . . . . . . . . . . . . . . . . . . .
SHOE AND LINING 4E–3. . . . . . . . . . . . . . . . . . . . . . . .
CALIPER 4E–4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ROTOR 4E–6. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
SPLASH SHIELD/BACKPLATE AND PARKING
BRAKE LEVER 4E–7. . . . . . . . . . . . . . . . . . . . . . . . . .
UNIT REPAIR 4E–15. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CALIPER OVERHAUL 4E–15. . . . . . . . . . . . . . . . . . . .
GENERAL DESCRIPTION AND SYSTEM
OPERATION 4E–18. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DISC BRAKE CALIPER 4E–18. . . . . . . . . . . . . . . . . . .
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Application NSm Lb–Ft Lb–In
Bleeder Valve 11 – 97
Brake Hose Caliper Inlet Bolt 32 24 –
Caliper Bracket Mounting Bolts 56 41 –
Caliper Mounting Bolts 31 23 –
Parking Brake Shoe Hold–Down Spring As-
sembly Screw
3.5 – 31
Rotor Detent Screw 4 – 35
Splash Shield Bolts 25 18 –
Wheel Hub Assembly–to–Spindle Shaft
Castle Nut
25 + 1* 18 + 0.7 –
* Tighten the castle nut up to 1 NSm (9 lb–in) as needed to align the castle nut cotter pin notch with the spindle shaft hole.
To Next Page
Loading...
Need help?
General
