AUDIO SYSTEMS 9F – 11
DAEWOO V–121 BL4
Installation Procedure
1. Install the rear speakers with the screws.
Tighten
Tighten the rear speaker screws to 4 NSm (35 lb–in).
2. Connect the electrical connector.
3. Install the deck lid sill plate trim cover and the right
side C–pillar trim panel. Refer tosection 9G, Interior
Trim.
4. Install the rear seatback and the rear seat cushion.
Refer to Section 9H, Seats.
5. Connect the negative battery cable.
REAR SPEAKERS (HATCHBACK)
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the rear speaker access cover.
3. Remove the screws and the rear speaker.
4. Disconnect the electrical connector.
Installation Procedure
1. Connect the electrical connector.
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
2. Install the rear speaker with the screws.
Tighten
Tighten the rear speaker screws to 4 NSm (35 lb–in).
3. Install the rear speaker access cover.
4. Connect the negative battery cable.