Daewoo NUBIRA User Manual

ENGINE CONTROLS 1F – 397
DAEWOO V–121 BL4
6. Disconnect the Crankshaft Position (CKP) sensor
connector from the fuel injector channel cover.
7. Remove the CKP sensor retaining bolt.
8. Gently rotate and remove the CKP sensor from the
engine block.
Installation Procedure
1. Insert the CKP sensor into the engine block.
2. Install the CKP sensor retaining bolt.
Tighten
Tighten the crankshaft position sensor retaining bolt
to 89 lb–in (10 NSm).
3. Connect the CKP sensor connector to the fuel in-
jector channel cover.
4. Install the accessory mounting bracket.
Tighten
Tighten the accessory mounting bracket bolts to 35
NSm (26 lb–ft).
5. Install the rear A/C mounting bracket, if equipped.
Tighten
Tighten the rear A/C mounting bracket bolts to 26 lb–ft
(35 NSm).
6. Install the A/C compressor, if equipped. Refer to
Section 7B, Manual Control Heating, Ventilation,
and Air Conditioning System.
7. Install the power steering pump, if equipped. Refer
toSection 6B, Power Steering Pump.
8. Connect the negative battery cable.

Daewoo NUBIRA Specifications

General

Brand	Daewoo
Model	NUBIRA
Category	Automobile
Language	English