Daewoo NUBIRA User Manual

INSTRUMENT/DRIVER INFORMATION 9E – 37
DAEWOO V–121 BL4
Installation Procedure
1. Install the chime module with the screws.
Tighten
Tighten the chime module screws to 4 NSm (35 lb–in).
2. Connect the electrical connector.
3. Install the knee bolster trim panel beneath the
steering column.
4. Connect the negative battery cable.
INSTRUMENT PANEL
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the floor console. Refer to Section 9G,
Interior Trim.
3. Remove the audio system. Refer to Section 9F,
Audio Systems.
4. Remove the HVAC controls. Refer toSection 7A,
Heating and Ventilation System.
5. Remove the instrument cluster. Refer to ”Instru-
ment Cluster” in this section.
6. Remove the A–pillar trim panels. Refer toSection
9G, Interior Trim.
7. Install the driver and passenger knee bolsters. Re-
fer toSection 9G, Interior Trim.
8. Disconnect the sun sensor electrical connector.
9. Remove the nuts and the bolts that secure the
steering column.
10. Lower the steering column.
11. Remove the screw that secures the instrument pan-
el to the heater air distributor case.

Daewoo NUBIRA Specifications

General

Brand	Daewoo
Model	NUBIRA
Category	Automobile
Language	English