Dell Networking N4000 Series User Manual

Using the Command-Line Interface 135
5
Using the Command-Line Interface
This section describes how to use the Command-Line Interface (CLI) on a
Dell Networking N2000, N3000, and N4000 series switches.
The topics covered in this section include:
• Accessing the Switch Through the CLI
• Understanding Command Modes
• Entering CLI Commands
Accessing the Switch Through the CLI
The CLI provides a text-based way to manage and monitor the Dell
Networking N2000, N3000, and N4000 series switches. You can access the
CLI by using a direct connection to the console port or by using a Telnet or
SSH client.
To access the switch by using Telnet or Secure Shell (SSH), the switch must
have an IP address, and the management station you use to access the device
must be able to ping the switch IP address.
For information about assigning an IP address to a switch, see "Setting the IP
Address and Other Basic Network Information" on page 147.
Console Connection
Use the following procedures to connect to the CLI by connecting to the
console port. For more information about creating a serial connection, see the
Getting Started Guide available at support.dell.com/manuals.
1
Connect the DB-9 connector of the supplied serial cable to a management
station, and connect the RJ-45 connector to the switch console port.
On N2000 and N3000 series switches, the console port is located on the
right side of the front panel and is labeled with the
|O|O| symbol. On the
N4000 series switches, it is located on the back panel above the OOB
Ethernet port.

Dell Networking N4000 Series Specifications

General

Brand	Dell
Model	Networking N4000 Series
Category	Switch
Language	English