500 Configuring Port Characteristics
Port Configuration Examples
This section contains the following examples:
• Configuring Port Settings
• Configuring a Link Dependency Groups
Configuring Port Settings
The commands in this example specify the speed and duplex mode for port 1
(gigabitEthernet 1/0/1) and change the system MTU size.
To configure the switch:
1
Enter Interface Configuration mode for port 1.
console#configure
console(config)#interface gigabitEthernet 1/0/1
2
Change the speed and duplex settings for the port.
console(config-if-Gi1/0/1)#speed 100
console(config-if-Gi1/0/1)#exit
3
Enable jumbo frame support on the interfaces.
console(config)#system jumbo mtu 9216
console(config)#CTRL + Z
4
View summary information about the ports
console#show interfaces configuration
Port Type Duplex Speed Neg Admin St.
--------- ------------- ------ ------- ---- -----
Gi1/0/1 Gigabit - Level Full 100 Off Up
Gi1/0/2 Gigabit - Level N/A Unknown Auto Up
Gi1/0/3 Gigabit - Level N/A Unknown Auto Up
Gi1/0/4 Gigabit - Level N/A Unknown Auto Up
Gi1/0/5 Gigabit - Level N/A Unknown Auto Up
Te1/0/1 10G - Level N/A Unknown Auto Up
Te1/0/2 10G - Level N/A Unknown Auto Up
Te1/0/3 10G - Level N/A Unknown Auto Up
Te1/0/4 10G - Level N/A Unknown Auto Up
Te1/0/5 10G - Level N/A Unknown Auto Up
--More-- or (q)uit
To Next Page
Loading...
Need help?
General