Script Commands 149
NOTE: The starting logical block address and the ending logical block address are
useful for very large single-virtual disk LUNs. Running a virtual disk consistency
check on a very large single-virtual disk LUN can take a long time. By defining the
beginning address and ending address of the data blocks, you can reduce the time
that a virtual disk consistency check takes to complete.
Clear Physical Disk Port Statistics
This command resets the statistics for all physical disk ports.
Syntax
clear allPhysicalDiskChannels stats
Parameters
None.
priority Specifies the priority that the consistency check
has relative to host I/O activity. Valid entries are
highest, high, medium, low, or lowest.
startingLBA The starting logical block address. Use integer
values.
endingLBA The ending logical block address. Use integer
values.
verbose Captures progress details, such as percent
complete, and shows the information while virtual
disk consistency is being repaired. To capture
progress details, set this parameter to TRUE. To
prevent capturing progress details, set this
parameter to FALSE.
Parameter Description
book.book Page 149 Wednesday, June 8, 2011 12:20 PM
To Next Page
Loading...
Need help?
General