Dell PowerVault MD3620f User Manual

Configuring a Storage Array 59
By default, all alert configuration settings are None.
The following example shows how to set the mail server IP and the sender
address configurations for SMTP alerts:
SMcli -m 123.45.67.89 -F
MyStorageArrayEvent@MyCompany.com
or
SMcli -m MyCompany.com -F
MyStorageArrayEvent@MyCompany.com
An example of a command to set the email alert destination and specify that
only event information is to be sent is:
SMcli -a email:MyCompanySupport@MyCompany.com
123.45.67.89 -I eventOnly
The following example shows how to set the SNMP trap alert configuration.
In this example, the trap destination is 123.45.67.891. The storage array is
123.45.67.892, and the community name is public.
SMcli -a trap:public, 123.45.67.891 123.45.67.892
Setting the RAID Controller Module Clocks
To synchronize the clocks on the RAID controller modules with the host, use
the set storageArray time command. Running this command helps ensure
that event timestamps written by RAID controller modules to the Major
Event Log (MEL) match event timestamps written to the host log files. The
RAID controller modules remain available during synchronization. An
example of the command is:
client>smcli 123.45.67.89 -c "set storageArray
time;"
Setting the Storage Array Host Type
The set storageArray command enables you to define the default host type.
The following syntax is the general form of the command:
set storageArray defaultHostType=(hostTypeName |
hostTypeIdentifier)
book.book Page 59 Wednesday, June 8, 2011 12:20 PM

Dell PowerVault MD3620f Specifications

General

Brand	Dell
Model	PowerVault MD3620f
Category	Storage
Language	English