Dell PowerVault MD3620f User Manual

Script Commands 169
Create RAID Virtual Disk (Manual Physical Disk Select)
This command creates a new disk group and virtual disk, and enables you to
specify the physical disks for the virtual disk.
NOTE: You cannot use mixed physical disk types in the same disk group and virtual
disk. This command fails if you specify different types of physical disks for the RAID
virtual disk.
Syntax
create virtualDisk physicalDisks
(enclosureID1,slotID1 enclosureID2,slotID2...
enclosureIDn,slotIDn)
[diskGroupUserLabel=[diskGroupName]]
raidLevel=(0 | 1 | 5 | 6)
userLabel=”virtualDiskName”
[capacity=virtualDiskCapacity
owner=(0 | 1)
cacheReadPrefetch=(TRUE | FALSE)
segmentSize=segmentSizeValue
usageHint=(fileSystem | dataBase | multiMedia)
enclosureLossProtect=(TRUE | FALSE)
dssPreAllocate=(TRUE | FALSE)
securityType=(none | capable | enabled)]
Parameters
Parameter Description
physicalDisks Specifies the physical disks to assign to the created
virtual disk. Specify the enclosure ID and slot ID for
each unassigned physical disk to assign to the virtual
disk. Enclosure ID values are 0 to 99. Slot ID values are
0 to 31. You must put parentheses around the
enclosure ID values and the slot ID values.
diskGroupUserLabel The alphanumeric identifier (including – and _) that
you want to give the new disk group. Enclose the disk
group identifier in square brackets ([]).
book.book Page 169 Wednesday, June 8, 2011 12:20 PM

Dell PowerVault MD3620f Specifications

General

Brand	Dell
Model	PowerVault MD3620f
Category	Storage
Language	English